Flank Worms of Worm Gear Hob
2022-08-26 15:20:35
jiangxingTools
2339
Flank Worms of Worm Gear Hob
the flank worms of a worm gear hob is determined by the flank form of the driving worm. The various flank forms are standardized in DIN 3975, which distinguishes between ZA, ZN, ZI, and ZK worms, according to the generating method.
Worm gear hobs are shank type worm wheel hobs, bore type worm gear hob, without single start, 2 start, or multi-starts, which can be made in HSS M2, M35, ASP30, ASP52, S390.
相关文章
-
Solid Gear Hob with Standard Dimensions
Solid Gear Hob with Standard Dimensionsthe following table shows that standard hob dimensions suited... - PA20° Profile DIN3972 Standard Gear Hob with Module m1.25
- PA20° PCD 100mm Pre-shaving Gear Shaper Cutter with Module m1.25~m6
- PA30° DIN5480 Involute Spline Gear Hob Cutter with Module m1.25
- PA20° PCD 200mm Disc Type Gear Shaper Cutter with Module m8~m12
- Nomenclature of HSS Gear Shaping Cutter
- PM-HSS ASP2030, ASP2052, S390 Module Gear Shaper Cutter with AP Coating
